Matrox Maevex 5150 Encoder

Descripción

The Matrox Maevex video distribution over IP solution consists of the Maevex 5100 Series encoder/decoder pair that extends 1080p60 video and audio over a standard IP network. Matrox PowerStream software is used to remotely discover and manage the Maevex network, allowing administrators to adjust multiple stream parameters. Based on a dedicated H.264 encode/decode platform, Maevex Series enables excellent-quality, cost-effective video extension and playback over standard LAN connectivity at user-defined low bit rates for minimal network bandwidth consumption.

Video and audio over IP
Operates on standard 10/100/1000Mb Ethernet networks
Excellent image quality with very low network bandwidth consumption
Cost-effective extension over standard COTS network equipment
Unicast, multicast, and multi-unicast operation
Auto-detection and discovery on network subnet

Integrated, solid-state encoding/decoding hardware architecture
Supports Full HD video and audio
Powerful, intelligent performance with dedicated hardware video decoding component
Open encoding platform also allows for third-party software decode*
Supports many resolutions and aspect ratios
Enables administrator fine-tuning of encoding and decoding parameters
Allows scaling of input resolutions before encoding and scaling of output resolutions after decoding

Network redundancy support
Hot plug/unplug support for power, video, and audio
Local real-time audio and video pass-through and confidence preview on Maevex Encoder
Integrated network switch on Maevex Decoder enables daisy-chaining, network extension, and redundant network topology
Failure resilience through power, network, and device auto-recovery features

PowerStream software suite
Powerful software application bundled with the Matrox Maevex Series
Remotely manage and monitor the entire Maevex network
Auto-populate Maevex network devices
Multiple-instance installation supported
Password-controlled user access
Access to device IDs, IP addresses, streaming state, bit rate, and other vitals

Optimized design for unbeatable performance
No driver components required on the host PC
No moving parts design for high MTBF
Low power consumption
Dust-resistant enclosure
High-density rack mountable
Small form factor

Maevex 5150 Encoder
Video Input:
HDMI with digital L-PCM audio
DVI via DVI-to-HDMI adapter
Resolutions up to 1920x1080p60, 1920×1200(60Hz) and many more wide-screen and standard-definition resolutions

Video Output:
HDMI with digital L-PCM audio, local pass-through w/o scaling or confidence preview w/ optional scaling
DVI-via HDMI to DVI-D adapter, local pass-through w/o scaling or confidence preview w/ optional scaling
HD15, Analog VGA – confidence preview w/ optional scaling
Resolutions up to 1920x1080p60, 1920×1200(60Hz)
Procamp control: contrast, brightness, saturation, hue
Scaled output (i.e., 1080p60 input/720p60 scaled output)

Audio Line-In: 3.5mm analog stereo audio
Audio Line-Out (Local Pass-Through): 3.5mm analog stereo audio
Network Connector: RJ45

Maevex 5150 Decoder
Network Connectors: 2 x RJ45 (fully switched)
Video Output :
HDMI with digital L-PCM audio
Resolutions up to 1920x1080p60, 1920×1200(60Hz) and many more wide-screen and standard-definition resolutions
ProcAmp control: contrast, brightness, saturation, hue
Destination cropping support

Audio Line-Out: 3.5mm analog stereo audio

Video Encoding / Decoding
Single-Channel HD: Up to 1920x1080p60 and 1920×1200(57Hz – TBC) and many more wide-screen and standard-definition resolutions
Compression Standard: H.264/Mpeg4 Part 10 (AVC)
Profiles: Baseline, Main, High
Levels: Up to 4.2
Bit Rates: 100Kbps to 25Mbps
Rate Control: CBR, VBR, Favor Speed, Favor Quality

Audio Encoding/Decoding
Compression Standard: MPEG4 AAC-LC
Channels: 2 channel (stereo)
Sample Frequency: 32, 44.1, and 48kHz
Bit Rates: 96, 128, 192, and 256Kbps

Networking Interface
10/100/1000base-T Ethernet
Streaming Protocols: UDP, RTP/RTSP/RTCP
Command & Control Protocols: HTTP/HTTPS
IPV4 Support
Unicast, Multicast and Multi Unicast
DHCP (Default) / Fixed IP Address Support
CAT5-or-Better Network Cables

Management Software
Central Command and Control Application
Resides on any PC network node
Maevex network configuration & control
Encoding and decoding control and manipulation
Frame rate and resolution control
Password protection
Failsafe over the network FW updates

OS Support: Windows 7/Windows 8 (requires Microsoft .NET 4.5)

Power Supply
100-240V AC In, 5VDC Out, 15W
DIN4 Locking Power Connector
Power Cords/Adapters Included: US, EU, GB/HKG, AU/NZL

Regulatory
CE/FCC/VCCI/ICES/C-Tick/KCC Class B
ROHS/WEEE

Environmental
Operating Temperature: 0 to 55 degrees Celsius (TBC)
Non-Operating Temperature: -40 to 70 degrees Celsius
Operating Humidity: 20 to 80% (non-condensing)
Non-Operating Humidity: 5 to 95% (non-condensing)

MTBF
Encoder: 135.05 years @ 40 degrees Celsius (excl. power supply)
Decoder: 164.81 years @ 40 degrees Celsius (excl. power supply)
External Power Supply: 11.45 years @ 25 degrees Celsius, full load
Fanless (no moving parts)

Mechanical
Dimensions Encoder: 21.59cm x 2.59cm x 10.16cm (8.50″ x 1.02″ x 4.00″)
Dimensions Decoder: 12.83cm x 2.59cm x 10.9cm (5.05″ x 1.02″ x 4.29″)
Weight Encoder: 378g (excl. external power supply and power cords)
Weight Decoder: 286g (excl. external power supply and power cords)
Rackmounting (optional rackmount tray)
Encoder: dual density – 1u
Decoder: triple density – 1u (horizontal mount); or 10-unit density in 3u (vertical mount)

Packaging Content
Maevex Encoder unit:
CAT5E Ethernet cable, RJ45 male to male, 6’/182.88cm
DVI adapter – DVI-D male to HDMI female
3.5mm analog stereo audio cable, male to male, 6’/182.88cm
Power supply, power cords and adapters (see “Power supply”)
Quick setup guide and release notes (if applicable)

Maevex Decoder unit:
Power supply, power cords and adapters (see “Power supply”)
Quick setup guide and release notes (if applicable)